How to move a refrigerator safely: defrost and drain it, pull the shelves, take the doors off only if needed, keep it upright, and wait before plugging it in.

Here's how to move a refrigerator without wrecking it, your floors or your back: unplug it the day before so the freezer defrosts, shut off and disconnect the water line, empty it and pull the shelves, tape the doors shut, then strap it to an appliance dolly from the side and move it upright with two people. Keep it standing up in the truck. If it has to lie down, put it on its side and let it stand upright before you plug it back in.
I run Commonplace, a marketplace for big, heavy things people would rather not haul themselves, and refrigerators are one of the items our crews pick up every week. They're tall, top-heavy, wider than you think once the handles are on, and full of parts that don't like being tipped. This guide covers how many people you need, the tools, when to take the doors off, how to get it through doorways and down stairs, how to load it, and what to do after it arrives. If you're moving it because you're selling it, you can list your refrigerator on Commonplace and our crew handles the pickup.
Yes, two reasonably fit people with an appliance dolly can move a standard freestanding refrigerator. One person can't do it safely, and a built-in unit is a different job entirely.
Weight is the first thing to respect. Most full-size freestanding refrigerators land somewhere around 200 to 350 pounds empty, and big French door and built-in models go heavier. Look up your model number (it's on a sticker inside the fresh food compartment) and check the spec sheet before you start. That number tells you whether a borrowed dolly is up to it.
Here's how I'd split it:
A refrigerator isn't heavy the way a safe is heavy. It's heavy and tall, which is worse. The center of gravity sits high, so the moment it tips past a certain angle it wants to keep going. Most of this guide is about never letting it get there.
The one tool that matters most when you move a refrigerator is an appliance dolly with a ratchet strap. A regular two-wheel hand truck can work for a short trip on flat ground, but the strap and the stair-climbing glides on an appliance dolly are what keep it from sliding off.
| Item | Why you need it | What to look for |
|---|---|---|
| Appliance dolly | Carries the weight upright | Built-in ratchet strap, rating well above the fridge's weight |
| Ratchet straps (2 to 4) | Holds it in the truck | Rated straps, not bungee cords |
| Moving blankets | Protects the finish and door handles | Two or three is enough |
| Painter's tape | Keeps doors and drawers shut | Blue tape, which peels off clean from stainless |
| Screwdriver and nut drivers | Handles, doors, kick plate | Most handles use hex set screws, so add a hex key set |
| Cardboard or floor runner | Protects floors from dolly wheels | Hardboard sheets for hardwood |
| Towels and a shallow pan | Catches water from the line and drain pan | Old bath towels work |
Measure before you buy or rent anything. Measure the refrigerator's width and depth, then every doorway, hallway and turn on the path out. That five minutes saves the classic mistake: a fridge wedged in a doorway with the doors already off the house.

Preparing a refrigerator for moving starts the day before. A fridge that's still cold, wet and full of shelves is the one that leaks on the stairs and rattles glass all the way to the truck.
If you're selling, this is also the right moment to clean it properly. We have a full guide on how to clean a refrigerator before selling it, and a clean, dry, odor-free fridge sells faster.
Usually not. You only take a refrigerator apart to move it when it won't fit through a doorway, and even then it's just the handles and doors, never anything inside the sealed system.
Start with the handles. On most stainless refrigerators they come off with a hex key on small set screws underneath or on the side, and pulling them can buy you a couple of inches of depth. Try that before anything bigger.
If you still need room, the doors come off. The general process on most French door and side-by-side models:
Every brand does this a little differently, so pull your owner's manual by model number from the manufacturer's site. It will show the exact hinge and wiring steps for your unit.
What you should never take apart: the back panel, the compressor, the coils or the refrigerant lines. Those are sealed for a reason. And if it's a built-in unit like a Sub-Zero, it's likely screwed into the cabinetry with an anti-tip bracket at the top. That's an installer job. Our Sub-Zero model guide covers which series are built-in.

The safest way to move a refrigerator through a house is upright on an appliance dolly, strapped from the side, tilted back no further than you need to roll it.
Put the dolly against the side of the fridge, not the front. That way the strap doesn't press on the doors, and the doors can't swing open even if the tape lets go. Slide the dolly's nose plate under, cinch the strap snug, and have one person tilt it back while the other steadies it. Tilt just enough to take the weight onto the wheels.
Protecting doors and floors comes down to a few habits:
For stairs, the person with the dolly handle stays above, and the second person stays below guiding and taking some weight. Go one step at a time. If there's a third person, put them on the high side too. Nobody should ever be below a fridge on stairs without a firm grip and a clear way out.
Transport a refrigerator standing upright. That's the rule I'd treat as non-negotiable whenever there's a choice.
Load it against the front wall of the truck or trailer, wrapped in a blanket, and strap it to the wall rails at two heights. Then pack the shelves and doors (if you pulled them) so nothing slides into it. In a pickup truck bed, strap it to the front of the bed and drive like you're carrying a full fishbowl.
If it truly can't go upright because of a low truck or a tight trailer, lay it on its side, not its back or front. The back has the condenser and the front has the doors. Check your manual, since some manufacturers specify which side.

After you move a refrigerator, stand it upright and wait before you plug it in. Lying down or bouncing around can let compressor oil drift into the cooling lines, and giving it time lets that settle back.
How long depends on the manufacturer and on how it traveled. A common rule of thumb is to wait at least as long as it spent lying down, and for a fridge that rode on its side, many people wait a full day. Your manual has the real number. If it rode upright the whole way, the wait is usually short.
Then level it with the front legs, reconnect the water line and check for drips, plug it in, and give it most of a day to reach temperature before you load food. Toss the first batches of ice, since the line may have air or sediment in it.
Hire it out when there are stairs, a built-in unit, a tight doorway that needs the doors off, or nobody to help you. Those are the moves where fridges get dropped and people get hurt.
What a professional charges depends on distance, stairs, whether the unit is built in, and whether you're adding water line hookup at the other end. Get a flat quote in writing that names those details. Some appliance retailers also haul away an old unit when they deliver a new one, which is worth asking about. If you're getting rid of it rather than moving it, our guide on how to get rid of an old refrigerator walks through selling versus recycling.
And if you're moving it because you're selling it, skip the move entirely. When a refrigerator sells on Commonplace, our crew comes to your home, disconnects it, wraps it, loads it and delivers it to the buyer. You don't touch a dolly. You can read how it works, or check what similar units sell for on our used refrigerator price index.
You can, but upright is better. If it has to lie down, put it on its side rather than its back or front, and let it stand upright before plugging it in so the compressor oil settles.
It depends on the model and how it traveled. A fridge that rode upright usually needs only a short wait. One that lay on its side should stand upright at least as long as it was down, and many people wait a full day. Check the manual.
Two, with an appliance dolly. Three if there are stairs. One person can slide it out from the wall on a flat floor, but nobody should take a fridge down stairs alone.
Only if it won't fit. Measure first, and try taking the handles off before the doors. Pulling the doors is a reasonable DIY job with the manual, but photograph the wiring at the hinges before you disconnect anything.
Yes. Unplug it about a day ahead so the freezer melts, then dry it and empty the drain pan. Otherwise you'll be moving a fridge that leaks.
Selling instead of moving? List your refrigerator on Commonplace and we handle disconnect, removal and delivery. Looking for one? Browse used refrigerators for sale, inspected and delivered.